Benchmark ADC16 Datenblatt Seite 46
- Seite / 153
- Inhaltsverzeichnis
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
ST72334J/N, ST72314J/N, ST72124J
46/153
13 MISCELLANEOUS REGISTERS
The miscellaneous registers allow control over
several different features such as the external in-
terrupts or the I/O alternate functions.
13.1 I/O PORT INTERRUPT SENSITIVITY
The external interrupt sensitivity is controlled by
the ISxx bits of the MISCR1 miscellaneous regis-
ter. This control allows to have two fully independ-
ent external interrupt source sensitivities.
Each external interrupt source can be generated
on four different events on the pin:
■ Falling edge
■ Rising edge
■ Falling and rising edge
■ Falling edge and low level
To guarantee correct functionality, the sensitivity
bits in the MISCR1 register must be modified only
when the I bit of the CC register is set to 1 (inter-
rupt masked). See I/O port register and Miscella-
neous register descriptions for more details on the
programming.
13.2 I/O PORT ALTERNATE FUNCTIONS
The MISCR registers manage four I/O port miscel-
laneous alternate functions:
■ Main clock signal (f
CPU
) output on PF0
■ A beep signal output on PF1 (with 3 selectable
audio frequencies)
■ SPI pin configuration:
–SS
pin internal control to use the PC7 I/O port
function while the SPI is active.
These functions are described in detail in the Sec-
tion 13 "MISCELLANEOUS REGISTERS" on
page 46.
Figure 28. Ext. Interrupt Sensitivity
ei2
INTERRUPT
SOURCE
IS10 IS11
MISCR1
SENSITIVITY
CONTROL
PB1
PB2
PB0
PB3
PB5
PB6
PB4
PB7
ei3
ei0
INTERRUPT
SOURCE
IS20 IS21
MISCR1
SENSITIVITY
CONTROL
PA1
PA2
PA0
PA3
PF1
PF2
PF0
ei1
- ST72334J/N 1
- ST72314J/N, ST72124J 1
- Table of Contents 2
- 2 INTRODUCTION 6
- 3 PIN DESCRIPTION 7
- (N versions) 8
- (J versions) 9
- 4 REGISTER & MEMORY MAP 13
- 5 FLASH PROGRAM MEMORY 17
- 6 DATA EEPROM 18
- Interrupt enable 21
- Latch Access Transfer 21
- 8 CENTRAL PROCESSING UNIT 23
- Half carry 24
- Interrupt mask 24
- Negative 24
- Carry/borrow 24
- 00000001 25
- MAIN CLOCK 26
- CONTROLLER 26
- ■ an external source 30
- ■ an external RC oscillator 30
- LVD reset flag 32
- Clock security syst 32
- interrupt enable 32
- Watchdog reset flag 32
- 10 INTERRUPTS 33
- INTERRUPTS (Cont’d) 34
- Table 5. Interrupt mapping 34
- 11 POWER SAVING MODES 35
- 12 I/O PORTS 39
- Hardware Configuration 41
- OPEN-DRAIN OUTPUT 41
- PUSH-PULL OUTPUT 41
- Data register 8 bits 44
- Option register 8 bits 44
- I/O PORTS (Cont’d) 45
- 13 MISCELLANEOUS REGISTERS 46
- Main clock out selection 47
- CPU clock prescaler 47
- Slow mode select 47
- Must always be cleared 48
- Beep control 48
- SS mode selection 48
- SS internal mode 48
- 14 ON-CHIP PERIPHERALS 49
- Activation bit 50
- 7-bit timer (MSB to LSB) 50
- Watchdog flag 50
- WATCHDOG TIMER (Cont’d) 51
- Time base control 53
- Oscillator interrupt enable 53
- Oscillator interrupt flag 53
- clock speed) with the choice 54
- 16-BIT TIMER (Cont’d) 55
- Beginning of the sequence 56
- Sequence completed 56
- /CC[1:0]) 58
- 16-BIT FREE RUNNING 59
- OLVL2OLVL1 64
- Pulse Width Modulation cycle 65
- Input Capture Flag 1 69
- Output Compare Flag 1 69
- Timer Overflow Flag 69
- Input Capture Flag 2 69
- Output Compare Flag 2 69
- CAPTURE STROBE 77
- VR02131B 77
- Write Collision status 83
- Mode Fault flag 83
- TDRE TC RDRF IDLE OR NF FE 93
- R8 T8 - M WAKE - 94
- TIE TCIE RIE ILIE TE RE RWU 94
- First SCI Prescaler 95
- SCI Transmitter rate divisor 95
- SCI Receiver rate divisor 95
- 8-bit Extended Receive Pres 96
- 8-bit Extended Transmit Pres 96
- CH2 CH1CH3COCO 0 ADON 0 CH0 97
- ■ A/D conversion [duration: t 98
- D7 D6 D5 D4 D3 D2 D1 D0 99
- COCO 0 ADON 0 CH3 CH2 CH1 CH0 99
- 15 INSTRUCTION SET 101
- Relative (Indirect) 103
- INSTRUCTION GROUPS (Cont’d) 105
- 16 ELECTRICAL CHARACTERISTICS 107
- 16.6 MEMORY CHARACTERISTICS 122
- 16.6.2 EEPROM Data Memory 122
- 16.6.3 FLASH Program Memory 122
- R=10k~10MΩ 124
- UNUSED I/O PORT 128
- ADC Accuracy 139
- 17 PACKAGE CHARACTERISTICS 140
- ■ Heraeus: PD945, PD955 143
- ■ Loctite: 3615, 3298 143
- MICROCONTROLLER OPTION LIST 146
- DEVELOPMENT TOOLS (Cont’d) 148
- 18.4 ST7 APPLICATION NOTES 149
- 19 IMPORTANT NOTES 151
- 20 SUMMARY OF CHANGES 152
Verwandte Produkte und Handbücher für Videokonverter Benchmark ADC16
(9 Seiten)© 2020, manymanuals.de. Alle Rechte vorbehalten. | 1.016 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern